Lpc1768 Kit

Kit özellikleri:

1. ARM Cortex M3 MCU (Model LPC1768 – NXP 32 Bits) with memory (Flash 512 KB , RAM 64 KB)
2. A/D 12 Bits , D/A 10 Bits
3. X ‘TAL 12.00 MHz (Max freq. 100 MHz with Phase-Locked Loop)
4. TFT Color 240 x 320 Pixels 3.2 inchs with
– Single Chip driver SPFD5408A
– Chip Touch Screen Contoller ADS7846 (On Baord)
5. In System Programming (ISP) and In Application Programming (IAP) by using On-Chip Boot-Loader via RS232 port (No need burning machine)
6. Real Time Debugging with 20 Pin Header JTAG ARM
7. USB 2.0 port full speed (Connector Type B on Board)
8. RS232 port (4 pins connector) 2 slots
9. Joy Switch (5 directions)
10. VR 10K for A/D development (0-3.3V)
11. 8 LEDs output , 1 Tact Switch , 1 Buzzer
12. USB Host Type A with over current protection
13. USB OTG with ISP1301 OTG(On-The-Go) Transceiver
14. Ethernet LAN 10/100Mb (RJ45)
15. Micro SD Card slot (SPI interface)
16. Support TFT LCD Color 320 x 240 Pixels (3.2 inchs)
17. Push Button Switch for RESET
18. RTC with Crystal 32.768 KHz and Battery backup (Optional)
19. 22 Bits GPIO for any application (D/A, I2C, I2S, CAN, In-Out 5V)
– 10 Pin Header P2(0-7) for GPIO or Full Duplex Serial UART
– 3 Pin Header P0(26) for GPIO or D/A
– 3 Pin Header P4(29) for GPIO
– 4 Pin Header P0(19-20) for GPIO or 12C Bus
– 4 Pin Header P0(0-1) and P0(4-5) for GPIO or CAN1 – CAN2 Bus
– 5 Pin Header P0(23-25) and P2(11-13) for GPIO or I2S – Rx/Tx
20. 5Vdc / 850 mA Power Supply (2 Pin connector or USB device with 3.3V/3A regulator)
21. PCB Size 15.3 x 9.0 cm.

Lpc1768 Kit

 

 

 

“Lpc1768 Kit” için 3 yorum

Yorumlar kapatıldı.